One fits all

 

TURBOFINS are designed to fit the vast majority of Kiteboards out there. Nevertheless, we didn’t want to sacrifice performance for those rare boards with extraordinary shapes, channels, rockers and concaves that do interfere with the wider contact patch between fin and board. As a rule of thumb, it can be said that, if there is more than 1,5 cm side by side clearance between the centre of the fins hole and the next upcoming channel, concave or edge and the most outer hole is not closer to the tip than 5 cm, the fin will fit just fine. 

​

Here is a list of boards which may interfere with the fin:

​

• ​Naish Monarch

 

Fit guarantee

​

If you order TURBOFINS and they don’t fit on your board which was not listed above please reach out to us, send a picture of the board and a short description why it doesn't fit.  You can send them back at our expense and keep all the included merchandise. We'll then add your board to our list.

​

Mix and match

​

You wonder which board benefits most from adding TURBOFINS? While the initial intend of the development was to make the most grippy board to facilitate overpowered take-offs, it turned out that it is just as valuable to add performance to a comfortable freeride board. The TURBOFINS increase it's performance to the level of a highend bigair board without sacrificing your knees on landing and chop. With the much increased upwind performance it even makes sense to mount them on your favourite lightwind board or door to get on the water even sooner. Just in case you don’t care about knees and light winds, throw them on your bigair ripper and experience grip like almost nobody has felt before.